Engineering Graphics

General Instructions Start time = 8.00 am End time = 9.00 am Upload time = 9.00 to 9.10 am 1. This test is of 1 hour 2. There are 4 questions in all 3. Draw neat projections on your drawing sheets 4. Upload your drawings within the timelines mentioned above Q1. Draw Isometric Scale of length 80 mm. (6) Q2. Draw the isometric projection of a square prism of base edge 30 mm and height 70 mm, placed on its square face on the HP with 2 of its base sides parallel to the VP.  (8) Q3. Draw the isometric projection of the hexagonal prism of base side 30 mm and axis length 80 mm, placed on the HP with two of its base sides parallel to the VP. (12)  Q4. A pentagonal pyramid of base edge 30 mm and axis length 70 mm is resting on the HP on its base with one of its base edges parallel to the VP. It is sectioned by a cutting plane inclined at an angle of 30 degrees to the HP and passing through a point 10 mm above the centre of its axis. Draw the FV, sectioned TV and the true shape of the section. 

 Assignment - Project Time Duration = 30 mins Upload time = 10 mins Max Marks = 20 Q1. Please make isometric projection of a pentagonal pyramid of base edge 30 mm and axis length 70 mm placed on its base on the HP using the CollabCAD  (10) Q2. Please make isometric projection of a hexagonal pyramid of base edge 35 mm and axis length 60 mm placed on its base on the HP using the CollabCAD (10)

 Assignment - Project Time Duration = 30 mins Upload time = 10 mins Max Marks = 20 Q1. Please make isometric projection of a pentagonal prism of base edge 30 mm and axis length 70 mm placed on its base on the HP using the CollabCAD  (10) Q2. Please make isometric projection of a hexagonal prism of base edge 35 mm and axis length 60 mm placed on its base on the HP using the CollabCAD (10)

Time duration = 30 minutes Uploading time = 10 minutes  Marks = 20  Q1. Draw Isometric Scale of length 70 mm.      (4)  Q1. Draw the three different laminae used in Isometric Drawing. (6) Q2. Draw the Isometric projection of a square prism of base edge 40 mm and axis length 70 mm lying on its rectangular face on the HP. Indicate the direction of viewing, mention titles and dimensions. (10)