Gib and Cotter Joint (4) - Disassembly of parts

-


Assignment : Gib and Cotter joint (4)

Question 1: 

Draw to scale 1: 1, the following views of the the Gib and Cotter joint


Part name: Fork end

1. Front View  

2. The Top View

3. The Side View 

4. Upper half in section

5. Full sectional Front View


Question 2:  


Part name: Eye end

1. Front View  

2. The Top View

3. The Side View 

4. Upper half in section

5. Full sectional Front View


Question 3: Part name: Gib

1. Front View  

2. The Top View


Question 4: Part name: Cotter

1. Front View  

2. The Top View


Draw the projection symbol, mention scale used, all the important dimensions and the titles.. 



Comments


Comments

Post a Comment

Popular posts from this blog

Sleeve and Cotter Joint - Assembly and Disassembly

-
Image
Dear Students, Good Morning and a warm welcome to today's class. It feels really nice to meet up for yet another class this morning. We will be studying about the Sleeve and Cotter Joint. An Isometric view of the Sleeve and Cotter joint is shown below  A Sectioned Isometric view is shown below Uses of the Joint 1. This type of joint is used to join or connect two rods having circular cross section area. 2. The rods may be stationary or revolving, whichever be the case. What is the material of the parts 1. The rods and the sleeve are made of Mild Steel (MS).  2. The cotters are made up of Steel (S).   Parts of a sleeve and cotter joint 1. Sleeve - 1 No. 2. Rods - 2 Nos. 3. Cotters - 2 Nos. Disassembly Drawings  You are required to draw the above mentioned parts separately and that too just one part of each type. For example, you have to draw only one sleeve, one rod and one cotter. Marks distribution This question is typically of 14 marks out of 28 marks i.e. 50 ...
Read more